Replacement method of tire
1. Park the forklift on a flat and hard road, turn off the engine and keep the forklift in no-load state.
2. Lower the fork to the ground and stop the wheel with the parking brake device. If replacing the drive tire, support the jack on the front side of the frame. If replacing the steering tire, support the jack in the center of the rear axle bracket.
3. Jack up the forklift slightly with a jack so that the tire is still in contact with the ground; First loosen the bolt fixing the inflation pipe, remove the clip, and then loosen the hub nut.
4. Fully support the vehicle with a jack, unscrew the hub nut and remove the tire.
5. The installation sequence is the reverse of the removal sequence. When installing the hub nut, the tightening torque must reach the specified value.
Note: after installation, check whether the inflation of the tire reaches the specified value. After running for a short distance, check whether the bolts of each part are loose.
