No matter what conditions the environment is, excavators must go downhill and downhill during their operation. Although very common, but there are many skills, how to drive the excavator quickly and safely up and down the slope of various angles? Ironman Manman compiled the skills of the old friends in the armour, and took you gently on the road.
Uphill slope
First, fasten your seat belt. Secondly, I should have confidence to be sure to go up, generally speaking, if the slope is less than 70 degrees and the ground is more rammed, it can basically go up, but we should also see the actual situation.
Observe if the angle of the slope is within the scope of the excavator, if the slope is too high, you can shake the upper half of the slope to the lower half, reduce the slope angle.
Align with the slope when going up, or you will lose your center of gravity easily, and always pay attention to the center of gravity when going up. Pay attention to the stones, carefully remove, climbing steeper slopes, small stones may also lead to small excavator track slippage can not move forward.
As far as possible to reduce the body's body center of gravity, as far as possible to reduce the arm, put the small arm to the head, keep the bottom of the bucket and the slope of 90 degrees, to prevent the excavator from falling into the bottom when the excavator suddenly slipped.
When the small arm is dragging the excavator to climb the slope, the excavator will slide down after loosening the arm. In this case, try to push the bucket deeper and climb up according to the additional force. When the arm receives the head, walk not to relax and keep the turn, so the material under the caterpillar will go down with the track. After the caterpillar, it can hold the excavator not to slide down, and then slow down the small arm to the head and go ahead, the deeper the better.
Don't loosen your arm easily when the crawler hasn't completely climbed over the top. Because the excavator is still tilted and the center of gravity is back before the crawl is finished, if the forearm is retrieved and the center of gravity is moved back, it is likely to cause a backward turn. So also grasp a climb, carefully loosen the forearm, lower the arm, at this time the arm must cooperate properly, as far as possible to avoid danger.
Downhill slope
The downhill and uphill areas have their own way of thinking, that is, keeping the center of gravity can keep balance.
Similarly, it is very important to pay attention to stone removal. Excavator track slippage can not be underestimated.
Be slow, and remember not to turn sharply. That way, the one-sided track of the excavator will be stuffed with rock and soil, and the track will not move if it gets stuck.
Make full use of the function of the bucket. No matter big or small slope, make sure that the excavator bucket first touchdown.
Any technology to become a master must be the time of grinding and experience accumulation, continuous learning, constantly try and sum up, I believe you will soon become an old driver!
