As we all know, the excavator's walking part is mainly composed of driving wheel, supporting chain wheel, supporting wheel and rail link. Each operation is indispensable to the operation, so when the operation of a certain period of time, these components will appear in varying degrees of wear and tear. The iron armor foam is here to share a few daily maintenance methods, which can reduce the wear of the excavator, and avoid a lot of time and energy to repair it in the future.
Iron armor for you to dispel doubts and reduce wear of excavator tracks
A method of reducing wear in the walking part of a excavator
The first point: if it is found that the wheel can not operate due to failure, it should be repaired immediately.
If a partial sprocket or a support wheel does not continue to operate, it may cause the roller to wear off and even lead to the wear of the rail link. Therefore, in the case of such roller can not run, it is necessary to immediately repair, so as to avoid other failures in time.
Second point: avoid excavators moving along the sloping ground or turning suddenly as far as possible.
Long time repeatedly walking and turning on the sloping ground will lead to the side of the rail link with the side of the driving wheel and the steering wheel, which leads to the increase of the degree of wear. Therefore, in the course of operation, it is possible to choose straight line and big turn as far as possible, which can effectively prevent excessive wear.
Third point: regular inspection, reinforcement bolts and nuts can effectively reduce track wear.
Load wheel, caterpillar bolt, drive wheel mounting bolt, running pipe bolt and so on, because the equipment works for a long time easily because of vibration and loosening. If the trackboard bolts are loosened and the equipment continues to operate, the gap between the bolts and the trackboard may occur, resulting in cracks in the trackboard. The gap can also increase the bolt hole between the track and the rail link, which leads to no means of fastening, resulting in the replacement of the track and the track chain.
Although the wear and tear of excavator track is caused by some small details, but it is these small details, if not paid attention to may lead to major failures and consequences. I hope you can share the experience with each other, learn and improve the maintenance operation skills, cherish and protect our revolutionary brothers.
