Summer, the increase of rain, regular maintenance and maintenance can help the machine to better cope with the various complex problems, in a better state with you together "fight side by side". In the summer, do the following three points, so that your love opportunity!
1. Inspection of road conditions can not be less
Rainy day road wet slippery, also easy to cause the ground water, urban roads are easy to appear problems, in the workplaces where we dig machines need to pay attention. In the mine, construction sites, a lot of work roads are soil roads, after heavy rain, the road is washed in the potholes, more and more mud pile up, the road becomes abnormal wet slippery. In this way, the road becomes abnormal wet slippery. In this case, the operator must check the road condition carefully and not rush to start work, so as to ensure safety first.
In the case of confirmation of the operation, observe the conditions of the road and the surrounding environment at all times. Avoid the excavators too close to the edges of the cliffs and gully. These places are soft and soft. It is very easy to fall or dump the machine because of the weight and vibration of the excavator itself. At the same time, it is necessary to avoid the machine working in the valley to prevent the rain from gathering on the mountain. Set up submerged machines. If working at night, the headlamps, working lights, ceiling lamps, instrument lights and wipers shall be regularly checked to ensure normal work.
Two. The cleaning of the excavator does not neglect
After the heavy rain, the excavator should be cleaned in time. Otherwise, there will be the accumulation of sludge in the space of the excavator, which leads to the rust of the important parts. The chassis is the most close to the ground, the influence of the road condition and the weather is especially serious and the rust spot is the most easily. Therefore, the cleaning of the excavators must be paid attention to in the rain cleaning. Clean and antirust treatment.
After rain cleaning, it can not only reduce the possibility of excavator rust, but also avoid the corrosion of acid in the rainwater. Therefore, it is better to give the excavator a paint surface early in the rainy season. These parts rust and then produce wear. If there is sediment or water inside the rotary gear ring of the excavator, further cleaning is needed to prevent the damage to the whole rotary system.
Three. Be careful to stop the excavator
It is also important to stop the excavator in the rainy season. If it is necessary, it is best to stop the excavator in the garage and avoid the excessive humid environment. If you need to stop for a long time, we should start the machine to run it regularly to recharge the battery. After a long time, the machine should clean the grease on the piston rod and add the grease to each part. In the machine, the machine should be added to the machine. During the parking period, the drying and cleaning of the working device should be kept so as to avoid the rusting of the machine. Do not stop in the low-lying area to prevent the excavator from being flooded in the low-lying area. At the same time, check whether the cover of the fuel tank and hydraulic oil tank is closed, the respirator is working normally, and avoid the unneed of the rain infiltration into the tank. Trouble.
