The slewing motor is the core component of the slewing organization of the excavator. The pros and cons of its working characteristics will immediately harm the slew rate of the entire equipment. The drive torque, slewing parking and parking brake are important for determining the output rate of the entire equipment. . However, it is also a pity. Swing motors are components that are prone to abnormalities in excavators, and they are complicated and expensive to repair, and spare parts are also expensive.
Common fault conditions and root causes:
When the excavator is working at a relatively low temperature, the driving force and the slew rate are not significantly reduced.When the oil temperature rises to about 60CC, the slewing force appears, the slewing speed ratio is unstable, and the speed is higher and sometimes lower.
The common failures mentioned above, in addition to the pumps, valves and other components in the rotary system software, the key is that the internal fitness exercises of the rotary motor cooperate with each other to cause damage, increase the gap, increase the leakage, and the pump oil cannot be discharged immediately. In addition, a lot of high-pressure hydraulic oil leaks, which causes the working pressure in the casing to increase, the temperature of the hydraulic oil rises, and the viscosity decreases.
inspection method:
1. Stability test
Use a blind plate to protect the fuel pipe of the slewing motor from the main fuel pipe, and use an oil pressure gauge to detect the vapor pressure of the slewing motor's forward rotation and overturning of the oil inlet and outlet to obtain the working pressure value of the slewing motor. Then connect the fuel pipe to make It is in all normal working attitudes, the excavator bucket is dropped and inserted on the road, the load of the rotary service platform increases, and the working pressure of the speed control valve when the motor driver is detected, and the two data tests are carried out to compare, you can judge Common fault conditions.
2. Total flow detection
Connect the PFM-6 steam flow meter in series to the oil passage, detect the total flow rate and working pressure of the rotary motor inlet and outlet, determine whether the rotary motor output torque and speed ratio exceed its technical performance parameters, and can distinguish the abnormality of the rotary motor position.
Common troubleshooting methods:
1) The damage to the gap between the plunger and the plunger hole of the engine block increases, causing a relatively serious gap leakage, and the plunger needs to be replaced.
2) The return spring is tired and its elasticity is reduced, causing collusion of the high-pressure and low-pressure fuel pipes of the engine block, and the spring needs to be replaced.
3) The sliding shoe and the plunger ball are damaged, which speeds up the dry friction between the sliding shoe and the pressure plate, which causes the rotation friction resistance to increase, and needs to be repaired or replaced.
4) The rolling bearing of the rotary motor is damaged, and the accurate positioning of the rolling bearing is invalid. The rolling bearing of the required model and specification needs to be replaced.
5) Valve EX200-1 needs to be repaired or replaced.
6) The hydraulic cylinder seals of the parking brake system are embrittled, ineffective, and oil seepage. The brake system cannot be completely eliminated, and the rotational friction resistance increases, and the sealing components need to be replaced.
7) The valve plate and the oil level of the engine block are damaged, causing internal leakage and weak rotation, which needs to be repaired or replaced.
8) Sealing components are gnawed, embrittled, and invalid, and should be replaced.
According to the detailed introduction in the article, many machine friends can figure out that this common fault can actually be avoided. If the customer can pay enough attention to maintenance when using the excavator, it will not cause such a big problem. damage. Therefore, the excavator maintenance and operation specialist once again reminded everyone that excavators are not invincible, so you must be careful and careful in daily maintenance, and you cannot ignore every key point!