It is strictly forbidden to stand on the fork when the electric forklift is in operation. When the auxiliary staff of electric forklifts are really needed, they should be equipped with special baskets for electric forklifts, and the forks should fork into the special fixing grooves under the baskets.
If the nature of the aerial work is inventory, labeling and other basically harmless work, the driver should not leave the electric forklift in order to provide timely assistance;
If you need to use metal tools to repair lamps and pipelines, electric forklift drivers can choose to wear a hard hat and sit in the cab to assist. Unrelated personnel should not operate the electric forklift.
In principle, electric forklifts are not allowed to overtake, but when overtaking stopped vehicles, they should slow down and sound, and pay attention to observe.
When driving, the height of the bottom of the fork from the ground should be kept 150-400mm, the mast must be tilted backward, and there should be a whistle to inform when there is someone in front.
Do not lift the fork too high when driving; when entering or leaving the job site or during driving, pay attention to the obstacles and obstacles; when the load is traveling, the fork must not be raised too high, which will affect the stability of the forklift.
When the forklift is driving downhill, it is strictly forbidden to turn off and slide, and it is forbidden to brake suddenly during the driving of the load under special circumstances.
After unloading, you should first lower the fork to the normal driving position before driving.
When turning, if there are pedestrians or vehicles nearby, the driving signal should be issued first. High-speed sharp turns are prohibited. High-speed sharp turns will cause the vehicle to lose lateral stability and tip over.
Forklift trucks must abide by the traffic rules in the factory during operation, and must maintain a certain safety distance from the vehicles in front. When passing through the door and intersection of the workshop, they should be slow, two look, and three pass; Lightly step on, change the lift, and don't step on or release or shake continuously ;.
When the forklift is running, the load must be at the lowest position that does not hinder driving, and the mast must be properly tilted backwards. In addition to stacking or loading, the load must not be increased. The height of the load must not block the driver's sight. When special circumstances affect the forward vision, drive at low speed when reversing
It is forbidden to turn on a slope, and it is forbidden to lift, lean forward during driving.
Forklift factory safe driving speed of 5 km / h, enter the production workshop area must drive safely at low speed.
When lifting or driving a forklift, it is forbidden for people to stand on the fork to hold items and play a balancing role.
If problems are found, they shall be repaired and reported in a timely manner, and they shall never carry out sick work or conceal them.
