1 brief repair
In the whole process of working or driving of construction machinery, if common faults occur suddenly, simple maintenance methods should be selected to enable it to drive or work reliably. For example, the diesel engine of the excavator suddenly shuts down while it is working, and the crankshaft rolling bearing of the diesel engine is found to be burned out during the inspection.
Because there is no replacement of spare parts on the spot, we choose solder wire to repair, and then use a fruit knife to repair the surface to a smooth and flat surface with suitable specifications. After cleaning and tidy, one-click installation, and the diesel engine is repaired.
2 trap
Construction machinery has been used for a long time, which will cause oil seepage, water seepage and steam leakage. It is more suitable for long-term construction machinery in tunnel construction. Due to the lack of indoor space during work, hydraulic or diesel engines are easy to produce. The common fault of water leakage caused by collision of automobile fuel tank.
Once such a thing occurs, you can use epoxy resin to reduce pressure or wipe it with soap to make emergency repairs. If there is a hole, you can use a bottle stopper to hold it, and when necessary, use a thin wire or rope to tie it up.
If the oil leaks due to the loosening of the three-way joint, you can use any raw tape to wrap around the external thread for 3-5 times and then tighten it.
3Rework
When working in the field of construction machinery, you should bring as many spare parts as possible, so that they can be replaced in an emergency.
For example, the damage and embrittlement of the hydraulic seal of the refrigeration water pump of a diesel engine will cause the water pump to seep because of the exhaust valve damage and embrittlement. The water pump will recover after the new exhaust valve is replaced.
Perhaps, it is more effective to replace the hydraulic seals of hydraulic cylinders, hydraulic oil pumps or hydraulic solenoid valves.
Also, it is easier and more convenient if the parts can be replaced, such as diesel filter or gear oil filter.
4 binding
When the anchor bolt at a certain point on the construction machinery is broken or the sliding buckle cannot be tightened, it may be considered to use thin iron wires and wooden sticks to be applied and bundled to temporarily repair the operation.
For example, when the standard pneumatic organization of the 74 type excavator is damaged, the front axle assembly is temporarily unable to be connected, and the off-road vehicle characteristics of the equipment are reduced, so that the suspension hydraulic cylinder cannot be locked.
When the front axle assembly must be connected, the fork shaft and the cylinder can be separated and the fork shaft can be pushed inward, and then the fork shaft will be fixed after one turn, so as to ensure the drive of the front axle assembly.
Similarly, this kind of rescue method can be used if the standard air pressure of the suspension hydraulic cylinder or the brake system organization decreases or there is no standard air pressure.
5 Disassembly
Under the premise of not jeopardizing the operation of construction machinery, the temporarily unnecessary and damaged parts can be dismantled.
For example, the generator set of the damaged diesel engine can be removed, and the battery can be temporarily used to supply the power supply system to the starting system for a short time.
Some parts can still be used in emergency after simple repairs after disassembly and assembly.
For example, after the gas production of a diesel engine is damaged, it can be removed for grinding, and the basic repair and the sealing of the valve seat ring can be used temporarily.
6 short circuit fault
If a component in the engineering machinery startup system software or control circuit is damaged, it can neither be repaired nor replaced without accessories, if the application conditions permit, it can be considered for short-circuit fault connection for emergency application.
However, it cannot be used for a long time. The heat value of the power circuit will often increase after a short-circuit fault is connected, and other power circuit components will be damaged. When the standard is reached, the damaged components must be replaced immediately to prevent new common ones. malfunction.
7 fill
After the bottom pressure high pressure oil pipe is damaged, other pipe fittings can be used to restore the original length to facilitate emergency maintenance.
For example, when the excavator has made the oil pipeline brittle or damaged due to long-term application, causing the oil pipeline to crack but cannot be plugged, the damaged part can be cut off and the plastic hose or Rubber hoses, etc. are sleeved on both sides of the oil pipeline to be fastened and connected.
8 deferred application
When construction machinery is working or driving, if the power circuit or hydraulic transmission system is damaged, part of the damage can be cut off and not used temporarily.
For example, the power line ground charge and discharge at a certain point of the diesel engine startup system software cannot be cleared for a while, and the positive stage can be suspended in the air to turn off the power supply, and only the ignition system power supply system is used for rescue. If one of the multiple series branch control circuits of the hydraulic transmission system is abnormal, the oil inlet pipe can be removed at this time and sealed with a pipe joint. Then, the other branch control circuits can still work again, waiting to work Repair immediately at the end.
9 replace
When a certain part of the construction machinery is damaged and it cannot work, it can be replaced by other parts in the car that have not yet harmed the work or parts manufactured according to local conditions. However, this type of maintenance method makes the characteristics of the construction machinery more repaired. Weak, generally only used when it is fully loaded.
For example, the engine belts of small excavators can be replaced by tapes and woven belts for shoulder bags in the short term.
