Construction machinery repairing and maintenance knowledge for brand equipments Factory China - New - Liteng Machinery

07/Jun2022

Forklift Work Procedure Specification Guidance

1、 Working procedure: (1) Qualification requirements Forklift drivers must be trained by the labor department and obtain a forklift driving operation certificate before taking up their posts. It is...

07/Jun2022

Forklift Maintenance Is Divided Into These Categories

Forklifts are also cars and need maintenance Because the forklift is widely used and its frequency is very high. We may not have known the maintenance specifications of forklifts because of work or...

07/Jun2022

Why Does The Diesel Engine Smoke? Analysis Of Blue Smoke, Black Smoke And Yel...

Example of agricultural machinery diesel engine 1、 Blue smoke emission: The reason for blue smoke emission is that there is excessive oil burning in the combustion chamber. The causes and troublesh...

07/Jun2022

Common Fault Causes And Treatment Methods Of Water Temperature Gauge Of Const...

Common faults of water temperature gauge: Turn on the ignition switch, and the pointer of the water temperature gauge always means that it does not move above 100 ℃. When the water temperature chan...

07/Jun2022

Used Forklift Makes A Lot Of Noise During Operation, How To Do?

Customers often complain that forklift trucks will make a lot of noise during operation. What is the reason for this problem? Next, we will uncover the confusion and analyze the causes of excessive...

07/Jun2022

Understand Some Faults Of Forklift And How To Eliminate Them

When the diesel engine of the forklift cannot be started? Cause of failure: 1、 Fuel supply system failure 1. Gas in fuel system Troubleshooting: use the oil transfer pump to remove the air in the s...

07/Jun2022

As A Forklift Driver, You Should Know These

1. What is the maximum lifting capacity and load center? What is their relationship? Answer: when the center of gravity of the goods and the load center are in the same vertical line, the maximum w...

04/Jun2022

Troubleshooting Method For Slow Moving Speed Of Working Device Of Komatsu PC3...

1. check the filter and clean or replace it if it is blocked Observe the oil and replace it if it is deteriorated. 2. check the pipeline in the hydraulic system If the conduit or joint is damaged, ...

04/Jun2022

Common Causes And Maintenance Methods Of Low Slewing And Walking Speed Or Lac...

Common causes of faults: 1. TVC valve is improperly adjusted. 2. there is a problem with the excavator servo mechanism. 3. there is a problem with the plunger of the Doosan excavator. 4. the excava...

04/Jun2022

Analysis Of The Schematic Diagram Of The Travel Motor Of YC35-6 Excavator

A. B is the working oil port, PP is the travel motor speed change (fast and slow) interface, which is connected with the travel speed change valve, and Dr is the oil return port, which is connected...

First 37 38 39 40 41 42 43 Last40/296

名媛直播

Knowledge

Forklift Work Procedure Specification Guidance

Forklift Maintenance Is Divided Into These Categories

Why Does The Diesel Engine Smoke? Analysis Of Blue Smoke, Black Smoke And Yel...

Common Fault Causes And Treatment Methods Of Water Temperature Gauge Of Const...

Used Forklift Makes A Lot Of Noise During Operation, How To Do?

Understand Some Faults Of Forklift And How To Eliminate Them

As A Forklift Driver, You Should Know These

Troubleshooting Method For Slow Moving Speed Of Working Device Of Komatsu PC3...

Common Causes And Maintenance Methods Of Low Slewing And Walking Speed Or Lac...

Analysis Of The Schematic Diagram Of The Travel Motor Of YC35-6 Excavator