In the process of daily excavators, we often face a variety of complex conditions. Then, in the complex environment, how to ensure the efficiency of the equipment while ensuring the safe operation of the equipment? Today, the Dou Shan explains the safety operation techniques of the excavator, and helps you to relax the various complex conditions.
1. Do not let the water exceed the upper branch wheel when the equipment is in the water. Do not let the tilt angle of the equipment exceed 15 degrees. If the inner water of the rotary bearing is inflow, the water is drained in time and the full grease is added, otherwise the engine or other structural parts can be damaged easily.
2, please accurately understand the terrain and work plane before starting work. If there is risk of rolling stones, please install window protection net.
3, do not make the hydraulic cylinder all out continuously, if the cylinder carries on the frequent complete expansion will cause the oil cylinder to be damaged; when the bucket meets the resistance on the ground, do not do the walking or the rotary action.
4, do not use the weight of the equipment to increase the digging force; when approaching the cliff, ensure that the working face of the equipment is firm, so that the walking motor is located at the rear of the equipment;
5, do not excavate the cornerstones below the equipment; do not use the bucket as a hammer or piling machine, otherwise it will easily damage the bucket or other structural parts.
6, when excavating, do not leave the track to leave the ground, otherwise it will easily damage the structural parts of the equipment; in the course of walking, the sudden start or stop should be avoided, and the walking device of the excavator should not be impacted when the walking control rod is operated before and after.
7. When the front end of the excavator is installed, the balance of the equipment should be maintained according to the weight of the equipment, and the operation should be carried out strictly in accordance with the requirements of the safety supervision and management personnel.
8, drivers need to put down the safety control rods before they stop working and leave the equipment, so as to avoid accidents caused by the incorrect operation of the external personnel.
