The fuel recommended by the excavator repair center: only use high-quality diesel (the fuel of a suitable brand should be selected according to different ambient temperatures), and kerosene is not allowed.
Add fuel
1. Park the machine on the first place.
2. Lower the bucket to the ground.
3. Turn off the automatic idling switch.
Important: If the steps to shut down the engine are not correct, the turbocharger may be damaged!
4. Run the engine with no load at low speed and no-load speed for 5 minutes.
5. Turn off the engine. Remove the key from the key switch.
6. Pull the pilot control switch lever to the locked position.
Note: Handle fuel carefully. Before refueling, the engine must be turned off. Do not smoke when filling the fuel tank or when the fuel system is working!
7. Fuel gauge on the monitor panel. If necessary, add fuel.
Important: Prevent all dirt, dust, water or other foreign objects from entering the fuel system! 8. When refueling the fuel tank, make sure not to spill the fuel on the machine and do not exceed the specified amount. The fuel tank has a capacity of 340L. When the amount of fuel exceeds the fuel tank filter, stop refueling. Be sure to fix the fuel nozzle to prevent the nozzle from damaging the fuel tank filter.
9. Reinstall the fuel filler cap on the fuel filler opening. Be sure to lock the fuel cap with a key to prevent loss or damage.
Note: Precautions for refueling with automatic refueling device: 1. When refueling with automatic refueling device, never forget to open the fuel filler cap.
2. To prevent excessive refueling, please stop refueling immediately when the amount of fuel exceeds the fuel tank filter.
Drain the fuel tank sump dirt---every day 1. For easy access, turn the car 90 degrees. Park the machine on level ground.
2. Lower the bucket to the ground.
3. Turn off the automatic idle switch.
Important: If the steps to shut down the engine are not correct, the turbocharger may be damaged!
4. Run the engine with no load at low idling speed for 5 minutes.
5. Turn off the engine. Remove the key from the key switch.
6. Pull the pilot control switch lever to the locked position.
7. Open the drain valve to drain water and sediment.
8. After the discharge is clean, close the discharge valve.
