Wipe with a dry cloth or anti-static cloth to keep the charger clean;
Do not use chemical or abrasive cleaning agents to avoid damage to the cabinet;
Must be protected from strong shocks from exposure or exposure to high temperatures and humidity;
Note on the use of the charger:
The charger should be disassembled and disassembled without authorization;
The charger is forbidden to disassemble and disassemble without authorization;
The charger should be placed vertically, in a dry and ventilated environment, to avoid moisture, away from flammable and explosive 名媛直播;
Under the condition that the battery is full, disconnect the input AC power first, and then disconnect the connection between the charger and the battery;
In the absence of people or long-term unused conditions, the AC power supply must be disconnected;
Do not cover the charger during the charging process, the ambient temperature of use is not greater than 40 ℃;
This charger is limited to indoor use, beware of rain;
It is forbidden to charge non-rechargeable batteries;
The interval between two boot-ups is not less than 10 seconds.
The charger should always be kept clean to prevent the intrusion of dust and moisture. When it is not used for a long time, it should be placed in a dry and ventilated place indoors and covered with a hood.
After a period of time, power should also be added to the tide.
During the charging process, the ventilation shutters on the cabinet cannot be shielded to ensure that the heat generated in the charger is diffused in time.
After the fuses in the input and output circuits are blown, they must be replaced according to the required specifications. The fuse must not be too thick and must never be replaced with wires. When the AC input voltage is 110 volts, the input current is 10.8 amps. When the AC input voltage is 220 volts, the input current is 5.4 amps. When two rectifiers work at the same time, the output current can reach 12A, and when one rectifier works alone, the output current does not exceed 6A. The appropriate fuse should be selected according to the input and output current.
The brushes of the sliding contacts of the transformer should be kept in good contact. When the part where the brush exposes the copper frame is less than 2 mm, it should be replaced in time.
