I did not wake up a friend to call, the morning just dry a small meeting on the opening of the pot, ask me how to do, because a friend is a new entry, I know that the circle of excavators can make money, the master is also a two knife, well, I telephone the remote control of the bar.
First let him check the periphery of the radiator is not blocked, his excavator reloading the building garbage in the flat, there are abandoned reed foil inside, it is easy to block the heat, after checking a little bit, clean after the effect is very little, good to continue looking for.
Second I let him look at the tank hydraulic tank, the pit and the gap in the middle of the two times, if found the original traces of sponges, now there is no, find something to plug up, the best use of foaming agent, but to pay attention not to spray too much, too many spillovers will overflow into the heat dissipation hole.
After checking the original car is not a piece, the next is the hardware store, buy back in accordance with the spray I said, waiting for half an hour, let the foaming fully solidify, try again, the European, working half an hour water temperature normal.
So the problem is, summer has arrived, the various small and medium-sized construction sites with hood and slant door work everywhere, or even directly removed. This is very embarrassing. A good car looks like this. It hurts too much.
How many repair masters have been defeated on the high temperature, and how many Mao Mao have lost in the high temperature road. A small high temperature, how many bosses day and night unavoidable, I have seen two months daily repair did not repair, a summer is so passed, you saw a big bucket on the machine to put a big bucket with drip irrigation technology to cool the machine? This is forced to what extent, this is what a tall man came up with.
Personally, the following points need to be examined in addition to the above two points:
One, check the water level, this is the most basic.
Two, check the water tank cycle, if you see the color of the water as the flood, Congratulations, I usually add two bottles of white vinegar, add water, the idle cycle of half an hour, put the water out, rejoin the water cycle and let out, if the color is very cloudy, then two bottles of vinegar, repeat again, to be careful When the water is released, the water on the engine body should be released together. Now many puppet masters can't find the water. Well, go straight out of the fire, and remember to extinguish the fire immediately.
If I find that the money is not in place, I will directly look for professionals. After all, there are specialties in the industry.
Three, the thermostat, which makes the gang love and hate the little thing, the summer because of it, how many excavators suffer torment, winter without it, how many cabs like ice cellar. My approach to it is simply and brutally, directly dismantling, ha ha, and then blocking the watercourse, and the individual has violent tendency.
Four check the water pump. This is very simple. When the water temperature is low, open the lid of the water tank, start the machine, and see the water fluctuation in the tank. I'm not very good at this, and I don't give it up.
Five check the fan to see the softness and the angle of the fan. I am looking for the same car for comparison.
Other reasons are all I do not understand, I hope you can add more, think of what electronic numbers, what a large amount of fuel injection, beautiful, hope everyone together to add.
