Do you know? Before we start the operation of the milling machine, do not rush to start the equipment. We should first check the belt and other parts of the milling machine to rule out the potential safety hazards of the milling machine. This article mainly introduces you.
The belt conveyor system of the milling machine adopts a two-level front-end discharge method, which is composed of an aggregated first short conveyor belt conveyor and a thrown second long conveyor belt conveyor. This design method makes the milling machine and the discharge truck The driver's operation is coordinated and convenient, and contributes to on-site traffic management.
When adjusting the belt of the milling machine, the tightness of the belt should be checked first. At the same time, the new belt should be readjusted after 4 hours of operation. The proper belt tightness must be maintained before the output horsepower of the engine can be transmitted to the milling machine. On the drum.
If the belt is too tight, it will aggravate the wear of the belt and reduce the life of the belt during the operation. If the belt is found to be broken or severely worn, do not think it can be ignored and should be replaced even if it is replaced. Big damage.
