Dongguan Taifu forklift Co., Ltd. is a comprehensive service enterprise specializing in forklift sales, forklift leasing, second-hand forklift sales, parts supply and maintenance. It now has Houjie company, Zhangmutou branch and Shenzhen Songgang branch. It is the largest second-hand forklift rental and sales company in the Pearl River Delta.
How to extend the service life of forklift charger? Taifu forklift comes to sue you.
Wipe with a dry cloth or anti-static cloth to keep the charger clean; Do not use chemical or abrasive cleaners to avoid damaging the casing; Strong shock from clicking or exposure to high temperature and humidity must be prevented;
The charger shall be disassembled and disassembled without authorization; It is forbidden to disassemble the charger without authorization; The charger shall be placed vertically in a dry and ventilated environment to avoid moisture and keep away from inflammables and explosives; When the battery is full, first disconnect the input AC power supply, and then disconnect the connection between the charger and the battery; Under the condition of no one or long-term use, the AC power supply must be disconnected; Do not cover the charger during charging, and the ambient temperature shall not be greater than 40 ℃; This charger is only for indoor use, beware of rain; Do not charge non rechargeable batteries; The interval between two starts shall not be less than 10 seconds. The charger should always be kept clean to prevent the invasion of dust and moisture. When not in use for a long time, it should be placed in a dry and ventilated place indoors and covered with a hood. After a period of time, it should also be powered on to remove moisture. During charging, the ventilation louver on the casing cannot be shielded to ensure the timely diffusion of heat generated in the charger. After the fuse in the input and output circuits is blown, it must be replaced according to the required specifications. The fuse should not be too thick and must not be replaced by wire. When the AC input voltage is 110V, the input current is 10.8A. When the AC input voltage is 220 V, the input current is 5.4 a. When two rectifiers work at the same time, the output current can reach 12 A. when one rectifier works alone, the output current shall not exceed 6 a. Appropriate fuses shall be selected according to the input and output current. The brush of the sliding contact of the transformer shall be kept in good contact. When the part of the brush exposed to the copper frame is less than 2mm, it shall be replaced in time.
