Core tips: how to install and adjust the Cat 325DL excavator speed motor? 1, connecting the connection of the governor motor to the computer wiring device; 2, the automatic governor motor calibration form of the starting control program level - 1, which determines the position of the controller's speed in the position of "10".
How to install and adjust the speed governing motor of Carter 325DL excavator? The steps are as follows:
1. Connect the wiring harness of the governor motor to the computer connector.
2. Starting control program level 1 automatic governor motor calibration form to determine the controller speed location in the "10" position.
3. Identify the acceleration cable from the interlayer (gray) and also face the rear cover of the motor. Steel wire forward, to the right to speed up the wire rope, so that the lock nut on the cable (end nut) and nut (rear end nut) to adjust the appropriate distance;
4, turn the belt wheel fully in counterclockwise direction, so that the joystick of the engine governor must contact with the high speed idle limiter.
5, the steel wire clip head of the steel cable is placed in the lower groove of the pulley and winding it in clockwise direction, so that the clamp head of the steel wire is inlaid tightly into the incision of the pulley.
6, turn the nut (the nut behind the end) until it attaches to the fixed bracket.
7. Tighten the nut 1-2 circles, then tighten the lock nut (nut at the end of the end) to fasten the accelerating cable to the bracket.
8. Turn the nut and the lock nut of the deceleration wire rope (or face the rear cover of the motor). Steel wire forward, left to speed up the wire rope, so that the lock nut on the cable (end nut) and nut (rear end nut) can be adjusted to the right distance.
9. The steel wire clip of the decelerating cable is placed in the upper groove of the pulley and is twisted against the pulley against clockwise, so that the head is embedded tightly in the grooves of the pulley.
10, tighten the nut (rear nut) to the support plane.
11, loosen the nut (the back nut) 2 circles, make it loose on the decelerating steel rope, tighten the lock nut (the nut before examination), make the decelerating wire rope fasten on the support.
12, install 2 sets of fixed clamp boards of governor motor cable.
13. Connect the wire to the wiring device;
14, start the engine and start the operation procedure function form to carry out "automatic G/A calibration";
15, after correct calibration, clear fault record data, see operation program level level - 1 of the "clear fault records" part of the content.
