Many friends often communicate with each other about the excavator squared method and skill, although many engineering machinery equipment now equipped with self leveling equipment, that is, GPS monitoring system, can carry on the vehicle positioning and running state monitoring and monitoring, and have automatic leveling power.
In spite of this, many areas or working conditions are affected by the limitations of the equipment. Most of the leveling work is still carried out by the excavator. Is there any skill or method for the excavator leveling?
Definition of leveling
Definition 1, leveling: it is generally measured by horizontal instruments, and is not an eye Ping. Large area leveling, the general distance of about 10 will be measured a little, how much, or how much. Consider the living dry method as a whole. There is a good number of pads where they are dug.
Definition 2, leveling: the earth heap is tall and short, and looks for a flatness in different places.
Summing up the skill of excavator leveling:
First, the excavator should stop leveling. If you want to get the floor flat, you must stop the excavator first.
Second, the leveling excavator should start looking from the side. Try to find it from left to right. It will be more accurate to see the doors and windows on the left side of the cab. You can also turn right to left. Don't start looking for it from the middle.
Third, the excavator dug from the left to the right to dig a bucket from one to one, to press 1 teeth at one time to make it flat, and to press a tooth in order to see that the running path of the bucket teeth below is not easy to dig deep, and it is easier to distinguish the highland.
Fourth, when the front is facing back, the interface should be adjusted on the flat surface. Do not see where it is high and dig there.
Fifth, when leveling, 10 centimeters of soil should be left as far as possible. If not 10 centimeters, we need to dig the soil low first.
Sixth, when excavators return their arms, do not always look at the bucket, just look at the flat surface. Look at the 4 sides of the left and right sides, lower the arm immediately, and try to reach 1 centimeters at the same time.
Seventh, remember to find the reference. You can also throw a brick on the surface that has been leveled as a reference. Of course, this is temporary. It is not recommended. It is mainly for practice. When you are not proficient, you should often get off to see and remember the feeling of leveling. In addition, the hand should be relaxed when leveling, and the hard work of hand is not very good.
The mound has a high and low level of leveling. Including these movements, push forward, go back to the ditch, pull and turn around, take the soil up and down. It's unequal to find.
The first is micromanipulation, how big the handle is, how much the car moves, and the bucket is more flexible than its own arm. It is the coordination between the hand and the brain.
The second is to see where the height is and where to put the soil. It must be considered as a whole.
