The operational micro adjustment of Kobelco -6E hydraulic excavator is set as follows:
1 arm rise speed
2 change of walking speed when straight forward
3 automatic transmission speed reversion time
4 arm extension speed
5 initial pattern set change
6 the low temperature mode is manually relieved (corresponding to the small arm (extension / recovery) swing at low temperature, and the possibility of changing the cumulative time compulsively).
7 arm regeneration rotation priority speed (small arm recovery rotation simultaneous operation to change the flow rate of rotation).
8 reduce the horse power manually set the change (when the special machine is switched off and prevent the high underground heating, and manually reduce the horse power).
9 adjustment of lifting load adjustment (possibility of overload alarm point adjustment)
1 shows the "after service diagnostic" picture assigned to each adjustment.
The 2 side is pressed according to the "operation mode selector switch" and enters the "adjustment mode" 3 times after the "operation light switch".
3 adjust the value according to the "operation mode selector switch", and adjust the value according to the buzzer stop switch.
4 after the "screen switch", the end.
The setting principle of N07 and N039 is not carried out.
N07: only when the hydraulic oil temperature is low, it is necessary to measure the speed of the small arm to set the "5" measurement.
N039: is 90% forecast warning point adjustment, 100% alarm points will not change.
All return to the initial value, so that the display "after service diagnostic screen" N040, press the 10 "operation light switch", activate the switch OFF..
