As we all know, there are many working accessories for excavators. In addition to the most common buckets, there are more common breaker hammers. Below we will continue to talk about the precautions after the excavator installs the breaker hammer.
1. After the excavator machine is installed with the breaker hammer, don't allow the arm and bucket cylinder to be exhausted. At most, it can only be harvested as shown above. As long as you exhaust it, the tip of the breaker will scratch a trace under the arm. , The boss can see at a glance what is going on.
2. After the excavator is mounted on the breaker hammer, it will stop when it stops, so that the swing frame is placed flat against the iron level of the flat car, so that the breaker hammer will not shake up and down during transportation of the excavator.
Everyone knows that the hydraulic tubing explodes to expel air, but if something is broken in the breaker hammer, it needs to be disassembled for maintenance. The first thing is to release nitrogen. Do you know? The place to release nitrogen is to disassemble the small screw above the tail and then use a screwdriver to top it. Be sure to release it slowly. If you release it too quickly, the gas will be frightening. If you do n’t release nitrogen, disassemble the torch head. If you check it, the four screws at the tail will pop out. It is very powerful and dangerous. In short, it is very dangerous to disassemble the torch head without nitrogen. It is very dangerous. Remember!
Some construction sites don't need a torch head. Do you just leave it in the wind and rain? The correct approach should be to cover the location of the butter with an article that can effectively waterproof (such as a cement bag on the construction site), because then the rain will not enter the torch, Tianqing then remove the bag and let the torch dry Sun, if you are a very responsible driver and the torch head is not used for a long time on the construction site, put the nitrogen off the tip of the breaker and advance it. This can ensure that there is no gap between the breaker and the middle steel body. This method is troublesome but greatly protected The life of the torch head.
