In the process of normal operation of excavators, many excavator drivers always encounter a headache problem, that is, the engine water temperature is high, especially in summer, and it often occurs. These seemingly simple problems, but let Many drivers have nothing to do. What situation caused such a thing, tell everyone how to solve it?
First of all, people need to figure out the reason for the high water temperature of the engine and understand the disease to which they belong, then they can deal with it.
1. The water temperature sensor is stuck.
2. The engine belt is broken.
3. The inside of the water storage tank is dirty. Cause blockage, use a temperature measuring gun to check the temperature around the water storage tank, the temperature below the blockage will be very low.
4. Insufficient fan speed ratio, common clutch failure.
5. Common failures of centrifugal water pumps.
6. The sealing tape near the radiator is damaged.
7. Sometimes the controller is broken and the false alarm is on the computer after all, and it must be the truth.
All normal engine water temperature is between 80 Celsius and 90 Celsius. If the temperature is higher than these temperatures, it will cause boiling, then I will check it by enumeration several times. After the water temperature is too high, it will run for a long time again, which will not only cause damage to the overall engine, but also The impact on the cylinder head gasket of the engine will cause immediate common failures and cause great damage to the owners.
In addition, the removal will be due to high temperatures, and the following should be paid attention to.
1. It must be noted that if the excavator is in a boiling condition, there is no need to stop the fire immediately. All normal low gears will be operated for a while to reduce the endothermic reaction, and the temperature will drop before standby.
2. When checking the radiator. After the machine boils, the temperature of the radiator of the water storage tank is very high. If you eagerly open the outer cover of the radiator at this time, most of them will always spray out boiling water, and the operator will burn and foam. At this time, the unpopular doors on both sides of the excavator should be opened so that the radiator can ventilate the product flow, speed up the skin temperature, and check when the temperature drops. Remember that you cannot use cold water to flush high-temperature components immediately. It is an engine. fee.
