Briefly introduce the steps of digging fish ponds, if not, welcome to add.
1, when a irregular fish pond is placed in front of you, first of all, we should observe the rough environment of the fish pond. It is mainly to observe where the silt of the cleaning is going. If you can pull away which is the best, it can not be pulled away, only heap on the edge or corner.
2. When you start off, try to use the fighter to have a deep view.
3, if it is a small excavator, I want to start this now, with a shovel, the best to drive the teeth in front, push the shovel behind, this you should understand, in case of a machine, at the very least to save yourself.
4, after going down to clean up a deposit of silt to help the side, do not need to clean up very flat, as long as you can ensure that your excavator will not be caught, it is OK.
5, after cleaning up, if the silt of the fish pond is much more, then the next step is to take the next step, dig up the old soil of the fish pond, make a more son up at a certain distance from the side, and the bank is better to sit straight. Before the bank is done, you should consider the silt that can be heap on this side, and the silt cleaned by this side. When digging the old soil of the fish pond, the distance must be good, the best way to the excavator, the farther the better from the excavator, the best distance from the other sides, the best distance from the other sides, the convenience to brush the slope.
6. After cleaning all the silt of the fish pond, then begin to brush the slope. (it is best to brush the slope for a few days.) my way is to brush the slope, and then brush the fish pond in the direction of counter clockwise. The car must go straight and the best, because the fish pond is all silt, when the slope is brushed. The slope of the edge toothbrush is not easy to brush out the slope is also not beautiful, but also unequal, it is better to use a side band of the fight son, first to do the upper mouth, first with the edge teeth to brush the excess mud down, and then use the edge of the bucket to scrape it over, to the lower mouth, the back belt must be straight, and you should pay attention to you do the angle of the slope angle on the car you should pay attention to. And the distance from the mouth to you, and when you brush backwards, you must always keep this angle, and use this method to brush all sides out.
7, and then dig a ditch along this hole, that is to stare at the foot, the role is to prevent the installation of six edges block collapse.
8, when you come up, you'd better bring more soil with you, because generally the place where the digging machine is located is poor.
9. When we come up, we will take the OK below.
