For excavators, loading is the most basic and simple activity.
There are two main types of loading: one is platform loading, the other is floor mounted. When conditions permit, of course, we will choose to sit on the platform. Its advantages are time saving, labor saving and efficiency. But in some cases, we can only choose flat loading.
It is still difficult for some newcomers to load the car in flat ground, so some construction sites will also choose to load the car as a check, the standard of assessment is the quality and speed.
Next, let's talk about some skills of flat loading, how to make the material fit the car well proportioned and ensure the speed. The key point of plain loading is occupying. We must make the dump truck parallel to the excavator.
The parallel distance between the dump truck and the excavator should be well controlled. The distance measurement method can be based on the watch arm. When the excavator transversely transfers the bucket to wait for the reverse, the angle range between the big arm and the small arm is between 90 and 110 degrees, so that even the horizontal rotation of the excavator will also have a Mi Ersan safe distance between the bucket and the bucket. By turning, you don't need to worry about the excavator. As for the back and back distance of the reverse car reversing position, it is too good to be able to reach the front of the excavator. The back will affect the line of sight of the excavator driver, and when the excavator is waiting, the driver is right in front of the driver.
In this way, the distance adjustment of the bucket and the excavator can be easy to load. When loading the car, either back and back, or from the back to front, it is necessary to take one bucket to a bucket. In the middle part of the big box of the car, if the digging machine, such as sand, should be sped out a little, the sand is scattered as it is not fully opened, so that the car will not be loaded.
Only when we have the best position can we save time, labor and efficiency.
