PC200-8 excavator rearview mirror installation position:
Install the rear view mirror (A1) and (B1) as shown below.
? rearview mirror (A1): 120mm (from the top of the pole)
? rearview mirror (B1): 100mm (from the bottom of the pole)
Adjusted rearview mirror (A1) and (B1)
The bolts (1) and (2) of the rearview mirrors adjust the rear view mirrors to enable the operator to have the best horizons behind the left and right side (these are the blind spots in the seat position of the self operated personnel).
Adjust the rear view mirror so that the operator can see the left and right sides of the machine.
Rear personnel (or 1 m high, diameter of about 30 cm objects).
Adjust the rearview mirror (C1) and (D1) adjust the rear view mirror, so that the operator can see the road within the 1m range around the machine from the operator seat position.
If the rearview mirror is difficult to move, loosen the screw (3).
Adjust the view of the rearview mirror of the PC200-8 excavator:
Adjust the rearview mirror so that the operator can see the following range.
? field of vision (left): 1830mm
? field of vision (right): 1500mm
? rearview mirror (A1): the shadow part must be visible (A2)
? rearview mirror (B1): the shadow part must be visible (B2)
? rearview mirror (C1): the shadow part must be visible (C2)
? rearview mirror (D1): the shadow part must be visible (D2)
