There are also ways to use small loaders to transport goods, but they cannot be loaded when transporting goods. It is necessary to carry out transportation according to the carrying capacity of the vehicle. Overloaded materials not only damage the vehicle but are also very unsafe. Next, we will introduce the common problems of loading cargo with loaders.
1. Before the goods enter the vehicle, it is necessary to confirm the net weight of the goods and the center of gravity of the goods. The wheels must not be loaded to prevent the raw materials from overturning. The load capacity of the handcart relies on two inserts, and the total width is relatively limited, so its center of gravity is very important for safety applications. The size of the goods or pallets should not exceed the size of the plug to prevent the trolley from being unbalanced.
2. Check the condition of the shelves, compressive strength, safety load capacity, and whether the pallets are broken and unusable.
3. Securely and safely tie up the goods, and the raw materials must be neatly stacked first. Boxed goods should follow the standards of being good at the bottom and small at the top, and heavy at the bottom and light at the top. When the cargo carried by the loader exceeds 1.5 meters, it should be securely tied.
4. When transporting spacious goods or heavy items, extra attention should be paid to prevent them from tipping over during use. Pay attention to safety when transporting pallets, iron wires, etc. to prevent injury or objects from collision. When carrying pallets, the number should not exceed 15 to prevent excessive pallets from rolling down on uphill and downhill roads and causing injury.
5. When the goods carried exceed the visual range of the operator's eyes and obstruct observation, the method of pulling the vehicle in front of the person should be adopted, and the backward push of the vehicle in front of the person should not be used to prevent collision with people and objects. It is not allowed to transport and lift goods that are too high on uphill, downhill, or uneven roads. At this time, the center of gravity of the goods is uneven, and if there is a small mistake, it will collapse randomly. Therefore, precautions should be taken. Do not force turns on uphill or downhill roads, as well as on uneven and crooked roads. When loading three-dimensional goods that are too high, it is necessary to monitor and be cautious when driving. Do not start the mining loader at high speed, change direction, or make sharp turns to prevent it from tipping over.
