The principle of Cat 325 excavator joystick is as follows:
When you release the joystick from any position, the joystick will return to the holding position (9). The superstructure movement will stop unless the rotary micro control device (such as equipped) is in the ON position. When the rotary micro control device is in the ON position, the rotary stop brake will not start until the rotary function controls the joystick. To the HOLD (hold) position 6.5 seconds later.
The operation mode of the machine is set from the original plant to the SAE system. The left and right ways are controlled by the left and right joysticks. The operation mode of the machine can be changed by changing the connection mode of the hydraulic hose.
The diagonal direction moving joystick can perform two functional movements in the same day. When you release the joystick from the position of the server, the joystick will return to the HOLD (9) position (9). The superstructure movement will stop unless the rotary micro control device (if equipped) is in the ON position. When the rotary tuning control is in the ON position The rotary parking brake will not start until the rotary function controls the joystick back to HOLD (hold) position for 6.5 seconds.
The machine control mode is initially set to SAE system control, and the left and right sides are controlled by the left and right joystick.
The machine handling mode can be changed by changing the connection mode of the hydraulic hose. Please consult Carter's agent.
The diagonal moving joystick can perform two functions simultaneously.
(1) variable speed mobile stick with variable movement to start special tooling. Move the variable joystick further to increase the speed of special tooling.
(2) turn on / off (On/Off) - push the switch to start the special tooling at constant speed. Push the switch again and disconnect the special tooling.
Cat 325 excavator joystick special tooling pedal:
Special tooling pedal has different functions when using certain assembly components. It is necessary to check its function before using special tooling pedal. The incorrect operation of special tooling pedal may cause serious casualties.
Special tooling pedal can be installed on any side of the treadle. Special tooling pedal allows the driver to adjust the speed of special gear. Variable speed on the front of the pedal, start special tooling. Further step down the pedal to increase the speed of special tooling. Disconnect the pedal to break special tooling.
At present, when special tooling is applied, lock pin (1) is placed in the lock (LOCKED) position (B) + the special tooling pedal is set to prevent any accidental operation of special tooling.
Note: to prevent the lock pin (1) from being accidentally pulled out, insert pin (2) through the incision (3) and turn the locking pin (1) counterclockwise to turn the 1/4 circle.
Special tooling (bi-directional oil flow) (if equipped) the following information is applicable to special tooling requiring bi-directional hydraulic oil flow. These tooling may also be equipped with loop circuits. Special tooling such as hydraulic shears, crusher, crusher and grab are typical examples of two-way hydraulic oil flow.
